THE INFORMATION IN THIS ARTICLE APPLIES TO:
The advanced properties described below affect EFT HA (active-active) configurations. These values are read upon EFT server service startup.
Specify the advanced properties described in the table in the format shown below. For more information about the Advanced Properties, refer to the online help for your version of EFT.
Additional cluster-related advanced properties:
whether to automatically detect private IP to advertise to other nodes.
Default value is "autodetect". You can replace
"autodetect" with the prefix of the IP address to find (e.g:
"192.168" to match an IP address starting with 192.168).
the type of coherence queue to use when using MSMQ. msmq-multicast uses multicast-based MSMQ queues to send administrative updates. msmq-iterative
uses point-to-point MSMQ queues (Unicast). Default value is msmq-multicast.
how much time (in seconds) EFT HA cluster node should wait for own multicast
MSMQ message to arrive to its own coherence queue before failing send
how much retry attempts EFT HA cluster mode should make when sending
multicast MSMQ message to coherence queue.
specifies the heartbeat period in seconds for clustered event rules. The
smaller the period, the sooner nodes will notice when another node has gone
down, but more frequent heartbeats incur increased overhead for the
production and processing of the associated event rule queue traffic.
Amount of time in seconds that an HA node will wait for incoming administrative messages to arrive before declaring itself to be out-of-sync with the cluster.
Enables advanced property below.
||0 (disables auto-draining)
|| 60 seconds
Amount of time in seconds that an HA node will wait for incoming administrative messages to arrive before declaring itself to be out-of-sync with the cluster and initiating draining and restart.
- Provide advanced property, ClusterOutOfSyncGracePeriodSecs, (above) and change the full timeout for sync default from 30 seconds to 60 seconds.
- Provide advanced property, ClusterOutOfSyncHealSecs, to set this value to non-default value.
- When EFT becomes out of sync and enters the period where it attempts to heal, the WEL text is output: "Node out of sync, attempting to heal...".
- The EFT.log shows:
- Time it entered into out of sync state: "Initial detection of node as out of sync, entering grace period..."
- Time it attempted to start healing itself: "Node out of sync, attempting to heal..."
Time it took to heal (if healed): "Node was out of sync for [N] seconds but is now in sync"
- Time at which it considered itself unable to heal; Time at which it began to drain: "Out of sync node unable to recover after [N] seconds, entering drain mode for maximum of [M] minutes. Service [will\will not] restart when draining is complete"
- Time at which it completed drain: Elapsed time for completing drain "Finished draining node after [N.XY] minutes"